Walk into any timber yard and you will quickly be asked one question: treated or untreated? It sounds simple, but choosing the wrong one can mean a fence that rots within a few years, or paying extra for protection you do not need.
Here is a clear guide to the difference between treated and untreated timber, and how to pick the right one for your project.
What is treated timber?
Treated timber has been impregnated with preservative, usually under pressure, to protect it against rot, fungal decay and insect attack. The pressure treatment process forces the preservative deep into the wood rather than just coating the surface, which gives it a much longer lifespan outdoors.
Pressure-treated softwood often has a green or brown tint, depending on the preservative used. Over time, this fades to a silvery grey if left unfinished.
See also: How Flat Roof Coatings Can Help Prevent Leaks and Extend the Life of Commercial Roofing Systems
Understanding use classes
Treated timber is graded by use class under the British and European standard BS EN 335. The two you will come across most often are:
• Use Class 3: For timber used outdoors but above ground, such as fence panels, cladding, decking boards and garden structures. It can get wet but is able to dry out.
• Use Class 4: For timber in direct contact with the ground or fresh water, such as fence posts, gravel boards, sleepers and decking joists close to the ground.
Using UC3 timber in ground contact is one of the most common reasons fence posts fail early, so always check the use class before you buy.
What is untreated timber?
Untreated timber has had no preservative applied. It is ideal for indoor projects where the wood will stay dry and protected, such as internal stud walls, shelving, furniture, joinery and any work that will be painted, stained or varnished.
Untreated timber is often a little cheaper and has a cleaner, more natural appearance. It is also easier to finish because there is no preservative residue to work around.
Which should you choose?
A simple rule of thumb: if it is going outside, use treated. If it is staying inside and dry, untreated will usually do the job.
Choose treated timber for:
• Fence posts, rails and gravel boards
• Decking frames and boards
• Garden sheds, pergolas and raised beds
• External roof battens and structural timber exposed to moisture
Choose untreated timber for:
• Internal stud walls and noggins
• Indoor joinery, shelving and furniture
• Projects you plan to paint, stain or varnish
• Temporary works and formwork
Look after cut ends
Pressure treatment does not always penetrate right to the core of the timber. Whenever you cut, drill or notch treated wood, apply an end grain preservative to the exposed area. It takes a few seconds and can add years to the life of your project.
Regularised and graded timber
For structural work such as floor joists and rafters, you will also need to think about strength grading. Timber marked C16 or C24 has been graded for strength, with C24 being the stronger of the two. Regularised timber has been machined to consistent dimensions, making it easier to build accurately. Your engineer or building control officer will confirm which grade you need.
Get the right timber first time
If you are not sure what your project needs, the easiest option is to ask. A good timber merchant will help you choose the right treatment, size and grade, and many can cut timber to length for you. William Hercock, an independent builders and timber merchant in Leicestershire, stocks treated and untreated sawn carcassing, planed timber, sheet materials and fencing timber, with a timber cutting service available.
You can visit the team at their depots in Melton Mowbray, Leicester and Oakham for expert advice on your next timber project.
